- #Right rear light housing connector not working how to
- #Right rear light housing connector not working driver
The tail lights (left and right) seem to go out within months of each other or in some cases right around the same time. Many X3 owners have noticed their tail light assemblies failing while still under warranty or even later at around 90,000 miles or so. The Issue: What is happening with the BMW LED tail light assembly? When you confirm it works put it back in and your BMW tail light is fixed.Ĭheck out the problem with this tail light and why the LED tail light failed below. Place cockeyed where the Valeo board was originally or hot glue into place as pictured below.Ĭonnect the tail light and test the light before putting it all the way back into place. This can be a tight fit but the LDD-500HW will fit within the assembly. Step 6: Mount LED driver within tail light Use hot glue if you kept the connector on to ensure the wires do not disconnect.
This will ensure they are solid and nothing disrupts them. Protect the connections you just made with heat shrink or electrical tape. White Whire on LDD-500HW can be clipped down and taped off.Blue Wire from LDD-500HW connects to Gray Wire.Yellow Wire from LDD-500HW connects to Pink Wire.Black Wire from LDD-500HW connects to Black Wire.Red Wire from LDD-500HW connects to Red on the connector.Whether you end up using the quick connector or cutting it off and soldering wires together, make sure the wires connect in the following order: They then finish it off with hot glue to make sure the wires do not fall out.
#Right rear light housing connector not working driver
Some have used the connector by clipping the LDD driver wires and sliding them into the correct notches of the connector. Step 3: Disconnect Valeo BoardĬut the wires at the start of the connector or if you would like to try and reuse the connector un-clip it from the circuit board. The inefficient board heats up too much and causes a weak connection. This is the simple constant current driver for the LEDs is the issue within the tail light. Step 1: Take out the tail light assemblyįollow the below video for the first 4 minutes in order to easily remove the tail light. Select wire connections and a 500mA output to get the correct model for this replacement. 7 Step DIY Guide to BMW LED Tail Light Repairįirst you must purchase the LDD-500HW.
#Right rear light housing connector not working how to
Below the guide check out exactly why this issue happened to understand how to troubleshoot other LED lighting issues. Follow the below guide to easily fix the BMW tail light by replacing the constant current driver. Here at LEDSupply we have a $6 part for this tail light repair. This issue has left many faithful BMW owners frustrated and looking for a solution.īMW has a good warranty system and if under warranty, BMW will replace the whole tail light assembly…unfortunately there is a design flaw within the tail light system that will cause it to fail just like the first. Unfortunately, the BMW X3 LED tail lights have become notorious in failing as early as 60,000 miles after purchase. One of these added features was LED lighting within the tail light assembly. The second generation BMW X3 F25 (years 2011-2017), like many other BMW models, added new style features to the high end mid-size SUV. One of these types of issues has been identified in BMW models (2011-Present). Not only do these failed parts damage the reputation of LED lighting but they also create short term problems for the owners as they now must deal with partially broken products that could be expensive to fix. Unfortunately, many manufacturers take shortcuts when designing these parts, using poorly designed and built electronic components. As LED lighting continues to improve and grow in popularity, more and more manufacturers are utilizing them in larger scale products such as household appliances and cars.
0 kommentar(er)
